Sig P365 Takedown Lever Stuck - Then manually release slide and it. It's possible the hole takedown lever goes in is off. Or the takedown lever itself may be slightly undersized. Curiously the finish on that part is very different. Almost purplish in color. As the title states my p365 xl has a dead trigger and a stuck takedown lever. I was at the range and made it through about 5 rounds before the trigger went dead. The gun was unfired before. Brand new p365, expected a slightly stiff take down lever upon first disassembly, right there at the ffl's counter. I dropped out the magazine, racked the slide back to show an. Just bought it, was trying to reassemble while getting familiarized with breakdown procedure and the dang takedown lever wonโt move down. Canโt get the slide to disengage. While hold the slide back at this position, with my right thumb over the take down lever, i started working the lever back and forth about 10 times. You should feel the tension on. The takedown lever is stuck as well in the 5 o'clock position. I was under the impression that if that was not in the 6 oclock position, it would not allow the slide to go. I go over the mechanics. Houses For Rent By Owner Accepting Section 8 Mnpitpoint Search Result
Then manually release slide and it. It's possible the hole takedown lever goes in is off. Or the takedown lever itself may be slightly undersized. Curiously the finish on that part is very different. Almost purplish in color. As the title states my p365 xl has a dead trigger and a stuck takedown lever. I was at the range and made it through about 5 rounds before the trigger went dead. The gun was unfired before. Brand new p365, expected a slightly stiff take down lever upon first disassembly, right there at the ffl's counter. I dropped out the magazine, racked the slide back to show an. Just bought it, was trying to reassemble while getting familiarized with breakdown procedure and the dang takedown lever wonโt move down. Canโt get the slide to disengage. While hold the slide back at this position, with my right thumb over the take down lever, i started working the lever back and forth about 10 times. You should feel the tension on. The takedown lever is stuck as well in the 5 o'clock position. I was under the impression that if that was not in the 6 oclock position, it would not allow the slide to go. I go over the mechanics.